|
|
People have
visited my page!
|
| |
| |
|
|
OPERATING INSTRUCTIONS
|
|
Non-Card System |
Card System |
-
Fill an ordinary foot bath basin with warm water
(temperature between 30~38˚C) and with water level up to the ankle.
-
Add a little salt to the water (best with refined salt).
-
Plug the array into the
output
II
socket of the device and place the array into the water.
-
Wear the treatment pads on your shoulder or anywhere you
like (refer to diagram below) and plug the other end into the output
I
socket on the device.
-
Turn on the power supply, insert IC Card (card system)
press start and set the time.
-
Place both feet into the footbath basin and set the
negative ions level (beginners - 1.6 to 1.8 Amperes). The timer will countdown from 30
minutes and the device will “beep” 4 times when the time is up,
indicating end of the
session. If you wish to continue using the device
for somebody else,
press the START switch again to begin operation.
-
Remove the IC Card & switch it off after use and remove the
plug from the power source.
|
|
Body Acu-point
|
| |
|
